Hm... maybe changing the sequence of the two maps !? Torsten
> Am 26.07.2019 um 17:07 schrieb Bill Gee <[email protected]>: > > Hello everyone - > > I seem to be missing something. I have made this work in the past, but now > it seems that Therion is totally ignoring my instructions. Argh! > > I have a part of the cave where a stream flow under a tourist trail overlook. > The original sketches were done on two different occasions, and I have drawn > them as separate scraps. > > When I set up the map in the .th file, I created a map for "MainPassages" and > another for "LowerStream". These are then collected into a single map. The > LowerStream map has options "[0 0] below". However, the compiled map always > shows it ABOVE. > > I tried adding a "break" between the two maps. I tried adding units to the > [0 0], and I tried changing the offset from [0 0] to [20 20]. None of these > made any visible difference in the compiled map. I tried removing the "join" > that connects the lower stream to the main passage, but all that did was make > for a sloppy join. The lower stream was still above the overlook area. > > I have other caves where I have done this, and it worked. What am I missing? > > Attached is the .th file I am using. > > Thanks! > > -- > Bill Gee > > <StarkCaverns.th> > _______________________________________________ > Therion mailing list > [email protected] > https://mailman.speleo.sk/listinfo/therion _______________________________________________ Therion mailing list [email protected] https://mailman.speleo.sk/listinfo/therion
