Break will not work in map definition from maps. Only sequence of particular maps works.
Martin Odesláno z iPhonu 26. 7. 2019 v 18:46, Tarquin Wilton-Jones via Therion <therion@speleo.sk>: > Hi Bill, > >> When I set up the map in the .th file, I created a map for "MainPassages" >> and another for "LowerStream". > > > You don't normally need to do this. You can just put the two scraps into > the same map like this: > > map outermap > mainpassagesscrap > break > lowerstreamscrap > endmap > > This will display the lower stream's scrap below the main passages > scrap. Or if you want to keep your two maps, then this should work: > > map outermap > MainPassages > break > LowerStream > endmap > > Make sure your .thconfig file has: > > select outermap@surveyname > > I think this is the most likely cause of your problem - if you don't > select the right map, Therion will select all of the scraps, without any > control over stacking order. > >> "[0 0] below" > > > This is something very different, and not related to stacking order. It > is used to offset a map from its natural position, and leave a shadow > "below" the other maps where it would normally have been. "0 0" would > not offset it at all, so you are asking Therion to draw the map in its > natural position, and leave a shadow ... also in its natural position > ... below the map. > > Probably not what you were looking for :) > > Hope this is useful. > > Tarquin > _______________________________________________ > Therion mailing list > Therion@speleo.sk > https://mailman.speleo.sk/listinfo/therion _______________________________________________ Therion mailing list Therion@speleo.sk https://mailman.speleo.sk/listinfo/therion