You might try this pin out set. It is for one of the 1150s but I believe most of the others are basically the same. They had quite a few different versions of the 1150 is the reason I say that. I purchased the remaining parts stock from them some time back and got quite a few schematics with it. Most of the changes were internal but some of them they changed the RF out to a SMA or other types of connectors.
Pin #1 Ground Pin #2 oscillator monitor Pin #3 Heater and main power input +15VDC Pin #4 RF output Pin #5 Ground Pin #6 + 8V regulated DC out for using with a electronic tuning circuit Pin #7 - EFT input Pin #8 + EFT input Pin #9 Oven Monitor On some units, pins 7 and 9 are reversed. The 1150FW unit has a different pin out than this. Chuck Norton Frequency Standards & Services ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]>; "Discussion of precise time and frequency measurement" <[email protected]> Sent: Tuesday, June 28, 2005 3:33 PM Subject: Re: AW: [time-nuts] Information about FTS-1200 > >>> > > And if it is any help I have the pin outs for a 1150 oscillator. It also > > uses a 9 pin connector. > > I got a few more pins from Marco. I got the full pinout for a FTS space > oscillator with a 9 pin DSUB. But the space oscillator pinout had no > resemblance to the pins I know on the 1200. > > I am all ears on the 1150 pinout! > > Thanks, > > Björn > > > > Bill K7NOM > > > > > > _______________________________________________ > > time-nuts mailing list > > [email protected] > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > > > > > _______________________________________________ > time-nuts mailing list > [email protected] > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
