[EMAIL PROTECTED] wrote:
You might try this pin out set. It is for one of the 1150s but I believe
most of the others are basically the same. They had quite a few different
versions of the 1150 is the reason I say that. I purchased the remaining
parts stock from them some time back and got quite a few schematics with it.
Most of the changes were internal but some of them they changed the RF out
to a SMA or other types of connectors.
Pin #1 Ground
Pin #2 oscillator monitor
Pin #3 Heater and main power input +15VDC
Pin #4 RF output
Pin #5 Ground
Pin #6 + 8V regulated DC out for using with a electronic tuning circuit
Pin #7 - EFT input
Pin #8 + EFT input
Pin #9 Oven Monitor
On some units, pins 7 and 9 are reversed.
The 1150FW unit has a different pin out than this.
Chuck Norton
Frequency Standards & Services
Some info clipped
And if it is any help I have the pin outs for a 1150 oscillator. It also
uses a 9 pin connector.
The pin outs for my 1150 are the same as shown above but I don't know
for sure about the voltages.
They seem to be the same.
Bill K7NOM
_______________________________________________
time-nuts mailing list
[email protected]
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
