Following the manual I started probing all the points that had AC & DC voltage specs listed.
Q1 & Q3 DC voltage is okay. I could not measure any AC voltage for Q1, and Q3 was a lot lower than the spec. CR5 was supposed to be -1.5V DC, but I was only measuring like +.5V? The C3/R3 point on the bottom (where blue wire is connected) was also a LOT lower than the AC spec. It says 1-4V p-p, but I was only in the millivolts. Red wire coming out of the oscillator I was measuring *maybe* 150-200mV p-p. BTW, found the replaceable parts page, it starts on page 32. I'm going to go ahead and measure Q3,Q4,Q5, and Q9 while I have it open. But I'm still as stumped as I was before. :( Jason _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
