I see Didier posted a corrected link to his site, were you not able to connect to mine?
I would not hook up a regular serial cable to a GPS4 as it uses non-standard things on some of the pins which could cause odd things to happen, for instance Pin-4 is a hardware reset! Anyhow, the manual tells you the complete pinout, and also the jumper settings to set the speed and such for the serial output. Probably just the serial speed needs to be adjusted. I suppose there is also a slim chance yours might have RS422 output, if so the manual describes which resistors are fit on the board for the output type. For any GPS-4 owners, which software version is yours running, oscillator module, and GPS module? Mine firmware is 017 and the engine program is 4850211-001. I could of sworn I saw one running a newer firmware, but whenever I contact the Brandwine people about it I get no response. I have the XTAL_1 (Medium Performance). Finally mine has the Furuno GT-77N1B-NF GPS unit. Jason _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
