); SAEximRunCond expanded to false Errors-To: [EMAIL PROTECTED] Hi All I'm trying to set up a supposedly NOS GPS development kit, similar to the old Motorola evalution kit, with an Oncore VP mounted on an interface board fitted with a 5 volt regulator and MAX232 interface chip. Running WinOncore12 under WinXP I can talk to the module ok, enter location info and get it to return it's ID etc, but other than that I can't get it to do anything. I've discovered from the VP command set that it goes into idle mode after a self test and needs a "position fix mode" command to put it back into "fix" mode. Unfortunately, although the module acknowledges the command it reports that it's still in idle mode. I'll dig out a DOS PC later, and try an earlier version of the software, but if anyone's come across this before I'd be grateful for any tips as to how I can kick it back into life again. regards Nigel GM8PZR
_______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
