); SAEximRunCond expanded to false
Errors-To: [EMAIL PROTECTED] RETRY
[EMAIL PROTECTED] wrote:
>
> Thanks Bruce,
>
> I hooked +12V and +5V up to it, but there is no heater current, and no LED's
> go on. There is however a small current into the +12V (90mA) and the 10.0MHz
> are being generated with a significant error since the crystal is at room
> temp.
>
> Wonder what I am doing wrong?
>
> bye,
> Said
>
>
Said
Yes with the oven cold the frequency error is much larger than for an AT
crystal.
One LED on the front of the PCB flashes green when the device is powered
up OK, another glows orange until the oven reaches temperature.
The LED near the input connector glows green.
LEDS near front of board:
Amber OFF |
|
OFF Green |
_________________
The oven current is quite high at startup.
The GPSDXO version requires around 24V@ 60W to startup (it has dc-dc
converters on the main board to produce +12V, +12V etc).
Amber led starts ON then after a while it flashes.
Then it turns off when OVEN is at operating temperature.
The green LED flashes throughout.
The other 2 LEDS indicate other conditions.
Bruce
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
