); SAEximRunCond expanded to false Errors-To: [EMAIL PROTECTED] RETRY Hi John,
I don't have this particular OAM Unit - I have a model 42-23 - but I do have the pin-out for it, and it sounds very similar to what you describe, so maybe this will be helpful. Viewed from above - ie as you would look down on it when on a board, with the pins to the left of the unit, they read from top to bottom as: 1 EFC IN - feedback from 10k trimpot for manual adjustment of Freq out 2 EFC REF - source voltage for 10k pot, hot end - cold end left open. 3 VCC +12v -heater supply? 4 GND 5 RF Out 6 VCC +10v - Osc supply? I expect your unit uses the same arrangement, but at least this should give you something to experiment with. 73, Dave, G4HUP / ND8P ----- Original Message ---- From: John Miles <[EMAIL PROTECTED]> To: [email protected] Sent: Saturday, 6 October, 2007 9:42:27 PM Subject: [time-nuts] Ovenaire OCXO pinout needed Does anyone have access to the schematics for a Gigatronics 1026 signal generator (50 MHz - 26.5 GHz)? If so, any chance you could look up the 10 MHz OCXO's pinout for me? I just picked up the OCXO from someone parting out a 1026, but have no other information on it, and I'm guessing the only hope for a pinout is to look in the original equipment's service manual. This is a nice-looking Ovenaire unit, similar but not identical to the one used in later-model Tek 49x spectrum analyzers. The model # is OSC 49-68. There are six terminals coming out of it, but that's about all I can tell. Thanks in advance for any info! -- john, KE5FX _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
