); SAEximRunCond expanded to false Errors-To: [EMAIL PROTECTED] RETRY In a message dated 11/3/2007 02:19:49 Pacific Daylight Time, [EMAIL PROTECTED] writes:
>Said >Another consideration is that for 10544A's and similar oscillators which >are only intended to drive high impedance loads( >= 1K) a simple 2 >transistor cascode buffer (or maybe a 10811A style common emitter stage >with series feedback in the emitter circuit) may be required to allow >them to drive a 50 ohm load or an RF transformer satisfactorily. A >cascode buffer has higher isolation than a common emitter stage. >Bruce Hi Bruce, that's a good point. The Fury can be turned into a high-impedance 10MHz input by removing resistor R38. This makes Fury also compatible with HCMOS OCXO's. But removing this requires soldering, which unfortunately would void the warranty.. bye, Said ************************************** See what's new at http://www.aol.com _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
