Thanks Abdul This comes as a pretty big blow, as this is what I was hoping to do with it from the start.
Is there a way to set it up to read one address continuously? thanks in advance-Patrick Prologix wrote: > Patrick, > > Prologix GPIB-USB controller does not work as a GPIB bus sniffer. In DEVICE > mode the controller reads the bus only if it has previously been addressed > as a listener. > > Regards, > Abdul > > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On > Behalf Of Patrick > Sent: Sunday, January 27, 2008 10:25 AM > To: Discussion of precise time and frequency measurement > Subject: [time-nuts] prologix device as sniffer > > Hi Everyone > > Thanks to all for helping me with my last post. I am now reading with my > Prologix device. > > I am just not sure that I am reading everything. I am trying to monitor > the communication between a closed source App and some GPIB devices. > > After I set up imported and set up serial with PySerial I tried this: > > ser.write("++mode0\r\n") > > x=1 > > def read3(): > while(x==1): > print ser.read(1000) > > I also tried print ser.readline() > > I read the "ID" command sent out by the software but I could not read > the response. Am I reading all the addresses with this set up or just > one? Does anyone have some thoughts on why I don't read the response? > > Thanks yet again in advance-patrick > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
