Several years ago I had an Odetics GPS receiver. I don't know if it's the same one you have or not but here's a little bit of what I know about the one I had. The data output was meant to work with a dumb terminal such as a Wyse. It had to be told where it was in order for it to lock up and required a software update to deal with Y2000. When I contacted Odetics about this they laughed at me and asked why I had this unit and told me to buy a new one. Prior to Y2000 I found that it drifted and at best was undependable. THe project I was on finally abondoned the Odetics in favor of DATUm 9130 series receivers. The support at Odetics left a bad taste in my mouth for them. I fianlly gave the receiver to a friend who wanted it becuase "it looked neat".
Burt, K6OQK - temporarily in Taiwan >>> Behalf Of Roy Phillips >>> Sent: 10 February 2008 09:52 >>> To: Time Nuts >>> Subject: [time-nuts] Odetics 325 - 865 >>> >>> Gentlemen >>> >>> Pleased to join you - I major in "high-end" test equipment, and have >>> recently added a couple of Watkins-Johnson Rx's -- Dual 8607 (20 - 2032 >>> MHZ) >>> ,and a WJ 8700 again dual LF/HF (to 32 MHZ). But I have now gathered a >>> couple of items of "Time & Frequency" . The first one is a Radio Code >>> Clock >>> RCC 8000, this receives the 60 Khz Standard frequency transmissions from >>> our >>> UK transmitter. This is fine - works OK. Now I have a bigger challenge - >>> I >>> found a ODETICS Model 325-865 SatSync which has been gathering dust >>> since >>> 1998 (last date it was active). >>> It was switched on (and no antenna was connected), I don't have one. It >>> came to life and scrolling its menu it shows a date in 1998 and a set of >>> co-ordinates which suggests it was probably a ship installation. I found >>> my >>> way to your site through searching for info on this item, and I gather >>> that >>> some of you have this item of equipment - can you help - I gather that it >>> requires an active antenna - what can be found or built to meet this >>> need? >>> Also the system is "Locked" - what do I do to clear this problem ( the >>> menu >>> display suggests I refer to the manual !!) Is it possible to obtain a >>> manual >>> or copy of such. I must admit that it is a very well made item and must >>> be >>> worthwhile to re-establish. looking forward to any help you may offer. >>> >>> Roy >>> _______________________________________________ _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
