Stanley, We will be looking forward to schematics and full firmware listing by next Friday.
73....Bill....WB6BNQ Stanley Reynolds wrote: > Update the receiver is working not sure if it is decoding time but powered it > up and was able to hear WWV. > > (1) Brown R14 100K to B+ > (2) Red R15 100 to pin 9 of U9 data in > (3) Orange R18 500 to B+ > (4) Yellow C47 pin 5 U16 from demod section receiver audio > (5) Green R16 &17 - R17 100K to B+ - R16 100 to 8 of U12 data out > (6) Blue 5 of U13 & 10 of U12 data in also enable (5) data out and start > search > (7) Purple Ground > (8) Gray Ground > (9) White 12 volt supply > > Pin numbers are the same on the board or case connector. > > You must touch or short pins 6 and 3 to cause the unit to cycle looking for > signal takes a few minutes then it goes back to sleep no audio. keeping the > short does not keep it on it is looking for a level change. > Used amplified computer speakers on pin 4 and ground for audio. > > > ____________________________________________________________________________________ > Looking for last minute shopping deals? > Find them fast with Yahoo! Search. > http://tools.search.yahoo.com/newsearch/category.php?category=shopping > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
