Dear Matthew,Attached you'll find I document which I'm planning to upload to my webpage (once it is activated). The TSIP settings you mention are correct, however TSIP is used on Port 2! (Port 1 can be configured for other protocols using TSIPCHAT).
The time/date problem I already figured out... it is caused by the RTC-chip (Real Time Clock). Maybe replacing it by a compatible chip could solve this problem.
If you have other questions.... just let me know! Best regards, Jeroen Matthew Smith schreef:
Hi I have just found your mail to the time-nuts list from last November - did you find anything out about the 23198-61? I have one here, but don't even know how to wire it up - not sure whether the power requires +5V or if it has an on-board voltage regulator and requires, say, +9V. I'm assuming that the D connectors are both standard RS232 in voltage level and pin-out, and with the PPS on pin 9, as it is with the Trimble Ace II (which has a very similar box). Does this thing run TSIP at 9600-8-1-N when booted? Anything that you can tell me would be appreciated. The date problem you were having is something to do with the GPS week number; this explains it (in case you had not found out yet): <http://tycho.usno.navy.mil/gps_week.html> Cheers M
-- Ing. Jeroen Bastemeijer Delft University of Technology Department of Electrical Engineering Electronic Instrumentation Laboratory Mekelweg 4, Room 13.090 2628 CD Delft The Netherlands Phone: +31.15.27.86542 Fax: +31.15.27.85755 E-mail: [EMAIL PROTECTED] GPS: Lat N52.00002 Lon E4.37157 Alt 46.2m
Trimble GPS receiver P.rtf
Description: MS-Word document
_______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
