Hello, All-- Thanks to the collective savvy of this list and the patient assistance of Ken Winterling <wa2lbi> I was finally able to get my Tbolt to stop requiring me to configure the COM-4 channel every time I ran the monitoring software.
So-- I had such good luck with that question, I'm going to pester the group with one more Tbolt question: In the "Position" area of the Tbolt monitoring display my altitude is given as 1.4 meters. The USGS topo map and a recent survey both say that the ground level at my house is 84 feet above MSL. The antenna for the T-bolt is on the top of my house 19 feet above the ground. If I open SETUP / POSITION and "SET ACCURATE POSITION" to, say....: 28 meters and enter that value, the indicated altitude changes to 28 meters, but the next day or so, I always find that it has reverted to 1.4 meters. Admittedly, having a (relatively) accurate altitude display is of minor importance to me since my primary reason for having the Tbolt is for a decent 10MHz reference. However, as a matter of principle it would be nice to have the altitude display be a little closer! Any suggestions as to how to get the Tbolt to display a more correct altitude? Thanks! Mike Baker WA4HFR Micanopy, FL --------------------- _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
