Hi David: Sorry about that. You're correct EOI and a number of the other control signals are not used. Do you have a complete schematic, mine has the left side missing and I can't read the names of the lines.
Have Fun, Brooke Clarke http://www.prc68.com/P/Prod.html Products I make and sell http://www.prc68.com/Alpha.shtml All my web pages listed based on html name http://www.PRC68.com http://www.precisionclock.com http://www.prc68.com/I/WebCam2.shtml 24/7 Sky-Weather-Astronomy Web Cam Dr. David Kirkby wrote: > Brooke Clarke wrote: >> But, since there's no micro controller you should not send any >> characters after the single command byte. No <CR><LF>, no <EOI>. You >> may need to explicitly set the termination sequence so that these are >> avoided. > > Looking at the manual on the HP 59306A, it says of the EOI line "Not > monitored or driven, terminated by resistive network". This rather > suggests to me it will make no difference whether the EOI is asserted or > not and so whether I open the device with > > dd=ibdev(0, gpib_address, 0, T3s, 1, 0); > or > dd=ibdev(0, gpib_address, 0, T3s, 0, 0); > > will make no difference. > > Dave > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
