Just got one on Ebay, it was reported with display problems and possibly not
working. The display problem was real but it appears to work fine. Thanks
Brooke Clarke his quick start for the 2100T works for the 2100F if you
substitute "ACQ" key for "Master" key. Fixed 1/2 of the display problem pushing
on the backside of the display but need to unsolder the back-light to remove
and reset the display I think. Also have the key bounce problem with the
tantalum caps, these small problems are very minor.
Don't have the GPIB interface but the chart output looks like it outputs a
voltage between 0-15 volts at the start with it tending toward the
millivolts volts as it continues. One cell site Rubidium/Quartz standard
getting to E10 4.7 to 5.0 overnight have another started today at E10 8. a
little higher start than the first.
Looking for some more info on operation and if setting the Time Constant to
3200GRIs is important ? Also have not set the total emission delay as I'm
guessing it has no effect except with the 2100T.
Stanley
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
