I have some drive time so I might give Wenzel a call and see how it goes. Meanwhile I looked around some more and found some with PTI oscillators. The pins are laid out in a square where as the Wenzel unit is in a straight row. The attached cable is the same with the same colors so I'm going to guess I can find the power and control leads. I'll make a test set up and start playing.
Got a few questions. When it says 12 volts, most times 13.8~ 14 should be fine? These are labeled 12 volts. Will that 12 volts need to be regulated? Do the specs look?decent? Here is a link to the PTI unit.? http://www.mtronpti.com/pdf/xo5051_datasheet51607.pdf Thanks Chris > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] > Sent: Monday, December 01, 2008 2:00 PM > To: [email protected] > Subject: [time-nuts] Wenzel Associates 100 Mhz osc > > I stumbled across a 100 Mhz oscillator. It comes from a > Harris Constellation RX/TX. > > According to the website part number is proprietary. So I > thought I would ask here or any info. > > Here is what is printed on it from top to bottom. > > 500-06769D > ISSUE 02 > PPD 786-020590-053 > 100 Mhz > +12 VDC > 0105-0201SSRG > > It has a SMA female or 100 Mhz out and 4 pins for power and AFC? > > _______________________________________________ > time-nuts mailing list -- [email protected] To unsubscribe, > go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
