Did you select the right comm port? I power mine off a lot and it has always come back.
-----Original Message----- From: VK3FGJM <[email protected]> To: [email protected] Sent: Wed, 21 Jan 2009 5:29 am Subject: [time-nuts] Tbolt monitor software Hi group, A strange situation has led me to ask a question about the Tbolt GPSDO and the Trimble Thunderbolt monitor s/w version 2.6. While re-arrangement of the shack, it's been idle for 3 weeks, Tbolt turned off. After turning the unit on and letting it settle some 2 hour, I connected the monitor program and found the following that I can not explain and correct:- * All SV and AMU have question marks * Product info has questions marks * the ability to see tracking status is blank. When last used, some 2 months ago to show a friend, the relevant display data came up, no issues. Further more, position, critical and minor alarms are green, disciplining status section such as DAC voltage DAC value mode and even it's 10MHz out etc etc is fine compared to my trusty Rubidium standard. Has any one seen this before and is there a setting that may have inhibited this feature? I have a screen shot, however it may be to large to attach, so let me know if this will help, I will be glad to forward it to some one with much more knowledge. Thank you in advance. Regards, Gerald VK3FGJM _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
