Hi Ulrich, since our FireFly and Fury GPSDO's support GPSCon as well, I tried your plot program. We use 115.200 baud by default, but when I set your program to that speed, it defaults back to 57600 for some reason. Changing our board's baud rate fixed that problem. Our status output is shown properly in your status window (see below), and the *IDN? string is shown as well, but the program says "the last smartclock status is undefined". What commands do you use to query the GPSDO that it may be getting hung up on? Your software looks quite nice, and It would be great if your software could support our units like GPSCon does.
Thanks in advance, Said The status window in your software shows the following: :SYSTEM:STATUS? AQUISITION ................................................ Tracking:10 Not Tracking: 3 PRN El Az SS PRN El Az 2 42 175 24 14 0 331 4 59 119 21 28 17 101 9 59 283 33 51 44 156 12 27 303 25 15 6 218 11 17 36 49 29 20 1 47 19 26 18 267 29 27 65 250 33 48 45 197 39 UTC 4:12:45 24 Jun 2009 LAT N 37:16:17.915 LON W 121:57:26.719 HGT 71.20 m (MSL) HEALTH MONITOR................................................ OCXO Current: OK EFC: OK GPS Receiver Status: 3D Fix 1PPS SOURCE MODE : GPS 1PPS SOURCE STATE : GPS GPSDO Status : Locked In a message dated 6/23/2009 02:29:05 Pacific Daylight Time, [email protected] writes: Z38XX talks to the Z3801/5/16 with a exact 10 s time base which means the PPS TI delivered can be used for the computation of Allan deviation (and other measures) of the internal phase comparator with a Tau0 = 10 s (which is done internally in Z38XX similar as in Lady Heather). The sat's horizont line in the Azimuth / Elevation chart will look strange in the first hours after program start. Give it some days until it looks as attched or even better. Have fun Ulrich Bangert _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
