I just received my TARP Tbolt and it has the 1 deg Temp steps. From the few 
test I've done so far, Looks like the neg effect is going to be quite 
noticeable at lab conditions where the temp changes only a couple degrees.  Any 
plans on making a replacement chip available?  I also have rev 3 firmware, 
Anyone know if that is going to make a difference in the replacement chip.

warren
*****************
----- Original Message ----- 
From: "Mark Sims" <[email protected]>
To: <[email protected]>
Sent: Saturday, July 25, 2009 6:04 PM
Subject: [time-nuts] TAPR Thunderbolt Temperature Reporting Question



The Tbolt uses the temperature reading to fine tune the oscillator 
disciplining.  It has a major effect on holdover performance (when the GPS 
signal is not available) and some effect on normal performance.   You can quite 
clearly see the effect of the temperature reading on the DAC setting in plots.

If the sensor produced a temperature reading that was directly proportional to 
the true temperature,  any error should be minor.  I don't think absolute 
accuracy is as important as relative accuracy since the Tbolt learns how the 
oscillator responds to temperature readings,  but your readings are WAY off.

The fault is almost certainly in the small eight pin DS1620 chip near the 
RS-232 connector.  There are two versions of this chip.  The ones before Rev E 
work much better than the later ones because they report the temperature in a 
way that can be resolved by the Tbolt firmware quite finely (around 0.01 C raw 
values).  The later chips report the temperature with a very crude 1 degree C 
granularity.  Search the archives for the details.

I found that the chips from:
    http://www.rentron.com/Products/Electronic-Components.htm
are Rev C chips and work well in the Tbolt.   The chip itself is cheap at 
$3.50...  shipping is not... it ran me around $11.  A group purchase/reshipment 
program might be useful.  I know of several Tbolts that had bad DS1620 chips.   
I had several,  but wound up sending them out.


----------------------------------------


Will this incorrect temperature be a performance issue ??  Is it 
fixable ?? Any suggestions as to where to look ?? 
_________________________________________________________________




_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to