jmfranke wrote:
I used a bias tee with a capacitor block. I varied the resistor until I could see signals coming from the external antenna, the built in patch was shielded with aluminum foil and the receiver verified that no signals were coming from the internal antenna. Some receivers needed only a 10K resistor, some models needed 220 Ohms.
In my case I still want it to pass 5 VDC, but let the receiver see some additional current, so I put a coil in series with the resistor, to not load the RF too much.
Cheers, Magnus _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
