I did something similar to my HP 5065A Rb standard, which had a 10811A
and a small plug-in card that was a digital IC doing a divide by two
followed by a simple LC filter. I picked off the signal right at the
chip input with a small cap and a piece of RG-174 that went to a buffer
amplifier (I used a two-channel prototype of the TADD-1 with a MAX-477).
It works fine, except that you need to use pretty loose coupling to
avoid loading the signal down to the point that there's not enough for
the divider to trigger on.
I suspect the 105 (and later 5061As that used 10811s) use the same
divider card, and the same treatment would work.
John
----
Ed Palmer wrote:
I was thinking more along the lines of an analog buffer, but you make a
good point. And if I want a sine wave output, I could use a simple pi
filter to clean it up. I have an HP 8647A RF generator that does
exactly that on the 10 MHz reference output.
Thanks!
Ed
[email protected] wrote:
Ed,
I have seen a hex schmitt trigger inverter used for this.
The output of the OXCO goes into all 6 schmitt rigger inverter inputs
and then on the output side you have the output leg of each inverter
connected through 300 ohm resistance. Thusly you get 6 hex schmitt
trigger inverters wired in parallel and with a combined output
resistance of 50 ohms.
Very simple and might be just the thing you're looking for.
John
KB1FSX Sent via BlackBerry by AT&T
-----Original Message-----
From: Ed Palmer <[email protected]>
Date: Mon, 07 Dec 2009 11:03:51 To: Time Nuts Mailing
List<[email protected]>
Subject: [time-nuts] HP 105B Modification
I have a late-model 105B Oscillator that's equipped with a 10811-60109
oscillator. It seems a shame to have that nice 10 MHz source without
having access to it. I was thinking of adding a buffer amp and
bringing out the 10 MHz signal. It shouldn't be too hard, but before
I reinvent the wheel, has anyone done this and do you have any
suggestions or advice?
Thanks,
Ed
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
