Hi
The 5345 should see it if it's set to 50 ohm termination and DC coupling. A
sweep of the trigger from about 1.5 to 3.5 volts should show it there over
most of the sweep.
Bob
--------------------------------------------------
From: "SAL CORNACCHIA" <salc...@rogers.com>
Sent: Sunday, February 07, 2010 11:06 AM
To: "Discussion of precise time and frequency measurement"
<time-nuts@febo.com>
Subject: Re: [time-nuts] No 1 PPS output on a Tbolt
Oscilloscope and 5345A Counter, the Tbolt software shows all green.
Best regards,
Sal C. Cornacchia
Electronic RF Microwave Engineer (Ret.)
________________________________
From: "Stan, W1LE" <stanw...@verizon.net>
To: Discussion of precise time and frequency measurement
<time-nuts@febo.com>
Sent: Sun, February 7, 2010 10:47:42 AM
Subject: Re: [time-nuts] No 1 PPS output on a Tbolt
Hello Sal,
What are you monitoring the PPS output with ??
It is a short duration pulse.
What does the TboltMON software (available at the trimble website) show ?
What does Lady Heather indicate ?
(She is just waiting to massage your numbers.)
Stan, W1LE
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
