Hi,I'm sure you know this, but using the handshake pins (RTS, CTS, DCD, DTR) Is a good idea from the point of protection if someone plugs a standard lead in. Use output pins if you are sending power out, input if sending in. Robert G8RPI.
--- On Sun, 14/2/10, Richard W. Solomon <[email protected]> wrote: From: Richard W. Solomon <[email protected]> Subject: [time-nuts] T-Bolt Schematic To: [email protected] Date: Sunday, 14 February, 2010, 4:06 Does anyone have a copy of the schematic for the Trimble T-Bolt ? I need to know if there is an unconnected pin on the RS-232 connector that I can run +12 vdc through. Thanks, Dick, W1KSZ _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
