I tried a 470 in parallel and the min. voltage came down to 3.6 or so. This did not seem to help much. 20:00 here, will try and experiment tomorrow.
A schematic would help to understand this. Any available ? There seems to be more trimpots and a couple of buttons the functions I have no clue about. >Suspect thats adjusting the c field. Would not hurt especially if the unit >was used/surplus. >Try 4000. > >On Mon, Feb 15, 2010 at 12:44 AM, Raj <[email protected]> wrote: > >> >> In my FE5680, I find that the trimpot for frequency adjust at one >> end 4.4V. The upper and lower voltages are 4.4 and 5.2 approx. >> >> Does this mean it is at the end of its life? >> >> There is a 4750 Resistor connected to the low end of the trimpot >> whose value can be reduced as a solution. Any experiences? >> >> Regards >> >> -- >> Raj, VU2ZAP >> Bangalore, India. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
