Stanley Reynolds wrote:
Sorry, the page you requested was not found
----- Forwarded Message ----
From: Stanley Reynolds <[email protected]>
To: Discussion of precise time and frequency measurement <[email protected]>
Sent: Thu, February 25, 2010 1:00:58 PM
Subject: Re: [time-nuts] Low noise voltage regulators
>From the :
"2-11. A single source of +20 to +30V dc with 10% regulation may be used to power both the oven and
oscillator amplifier circuits if a simple IC regulator is used. A suggested
circuit is shown in Figure
2-1. The resistor and capacitor connected to terminals 3 and 4 of the IC
minimize ripple and noise
in the regulated output."
www.n4iqt.com/hp/12volt-reg.jpg
I have planed to separate the power supplies from my test stands as my next project for the 10811's so I'm also interested in a suitable supply. Considered a battery supply with a regulator for the 12 V side.
Stanley
10811A/B Quartz Crystal Oscillator Operating &
Service Manual (V2)
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
