And, many moons ago, they gave folks who had gut surgery a high strength Coke. Worked great in dissolving stuff in the innards.
73, Dick, W1KSZ -----Original Message----- >From: Robert Atkinson <[email protected]> >Sent: Mar 21, 2010 5:23 PM >To: Discussion of precise time and frequency measurement <[email protected]> >Subject: Re: [time-nuts] HP 5065A rubidium lifetime > >There is a common use for Phosphoric acid. It's used as a rust conversion >compound. Jenolite is a trade name in the UK, not sure about in the USA.Oh, >and it's in Coke, hence the old penny cleaning trick. >Robert G8RPI. > >--- On Sun, 21/3/10, paul swed <[email protected]> wrote: > >From: paul swed <[email protected]> >Subject: Re: [time-nuts] HP 5065A rubidium lifetime >To: "Discussion of precise time and frequency measurement" <[email protected]> >Date: Sunday, 21 March, 2010, 20:43 > >Were do you obtain a small amount of phosphoric acid???? >Also when I looked it up they said it was H3PO4. Doesn't sound like the >same. >Is there a common use for it? > >On Sun, Mar 21, 2010 at 1:58 PM, randy hunt <[email protected]> wrote: > >> Try measuring a known length of the resistance wire, say 6 inches and then >> double. . . >> >> Randy >> >> Hi >> >> Next step would be to figure out what a reasonable ohms / foot number >> is. >> >> Bob >> >> >> On Mar 21, 2010, at 12:41 AM, Chuck Harris >> wrote: >> >> > HP just wound two parallel wires around the cylinder. They >> did not >> > twist. The wires at the entrance end of the solenoid went to >> the >> > electronics, the wires at the exit end of the solenoid were >> shorted >> > together... I think they used a crimp for the short. >> > >> >> > -Chuck Harris >> > >> > J. L. Trantham wrote: >> >> Do you >> make a 'twisted pair' and then wind that or just wind two parallel >> >> >> wires around the cylinder? >> >> Joe >> > >> > >> _______________________________________________ >> > time-nuts mailing list >> -- [email protected] >> > To >> unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> > >> and follow the instructions there. >> > >> >> >> >> _______________________________________________ >> time-nuts mailing >> list -- [email protected] >> To >> unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and >> follow the instructions there. >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> >_______________________________________________ >time-nuts mailing list -- [email protected] >To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >and follow the instructions there. > > > > >_______________________________________________ >time-nuts mailing list -- [email protected] >To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
