Mike, It would still output data at 9600 moto bin(after sending @@Ci). I also tried successfully to turn on the Hn string. I'm doing something wrong, or there is something I'm not doing right.. Thanks Norm ---- mike cook <[email protected]> wrote: > Hi Norm, > hmm. doc says that the command willl switch the port to 4800, so you > should see no coherent data at all immediately that the command is > executed. Were you still getting 9600 data without resetting the device? > Would it respond to MBP commands after the @@Ci ? > Mike > > Le 30/05/2010 11:04, [email protected] a écrit : > > Hi all!! > > Trying to get a gt+ setup(also tried one of my m12+t's) as a nmea receiver. > > @@Ci does not work. Did form the string correctly. > > Tried it with tac32, used Labview to send the hex string. > > Receiver ignores it and continues to send moto bin at 9600.. > > Any ideas?? > > Want to use this for a balloon flight with aprs. Good news is that we want > > to launch Friday, so it's not too pressing. > > Norm n3ykf > > > > > > _______________________________________________ > > time-nuts mailing list -- [email protected] > > To unsubscribe, go to > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > > > > > > > > > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there.
_______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
