I don't think they can do anything with .PDFs, but if you can come up with Gerbers, check out http://www.batchpcb.com . Great service on 2-layer boards, somewhat slower on 4-layer boards since they take longer to accumulate a full panel from other customers.
-- john, KE5FX > -----Original Message----- > From: [email protected] [mailto:[email protected]]on > Behalf Of Dick Moore > Sent: Wednesday, August 11, 2010 11:12 PM > To: [email protected] > Subject: [time-nuts] one-off PC board > > > I have a board layout that I need made, simple single-side, 2.3 x > 6.5 inches. Any suggestions on where I can get this made at a > reasonable price? The mask layout I have is a printout from a pdf > document that has black where the traces are and is full-size. > > Others may be interested -- this is for Bob Cordell's > state-variable low-distortion oscillator (similar to a Tek > SG505), which delivers THD around 3ppm in the audio mid-band, > works from 10 or 20Hz up to 100 to 200kHz, with generally very > low distortion overall. A very nice inexpensive way to get great > amplitude stability and ultra low THD, with output up to > 10VRMS... I built this unit years ago, and now, after selling > mine, I've discovered I'd like to have one again. > > Best, > Dick > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
