Isn't the temperature inside the OCXO oven held at a set point (greater than
ambient) with it own independent thermostat? The DS1620 thermometer only
reads ambient temperature. In this case amibent means inside the Tbolt
enclosure.
If so, what does the Lady Heather "t t" command do? It prompts you to
"enter desired operating temperature". What could it control?
Russell (newbie)
----- Original Message -----
From: <[email protected]>
To: "Discussion of precise time and frequency measurement"
<[email protected]>
Sent: Tuesday, September 28, 2010 12:32 AM
Subject: Re: [time-nuts] antennas
Instead of reacting to a change in the OCXO, the control software can be
proactive wrt a change that is heading towards the inside of the oven.
--
Björn
What is the purpose of the temperature sensor chip on the PCB, anyway?
Isn't the temperature inside the OCXO much more important?
--
Mark J. Blair, NF6X <[email protected]>
Web page: http://www.nf6x.net/
GnuPG public key available from my web page.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
