>From what I have seen on those. They take 10 mc and make 15. So just tap the 10 and divide. I use the 10 mc straight out buffer it and distribute it around on 75 ohm cable. You could actually I might guess just bypass the pals and drive into the mmics as outputs.
On Mon, Oct 11, 2010 at 7:12 PM, Rex <r...@sonic.net> wrote: > I haven't seen the XO version (I have a similar Rb) but they no doubt make > 15 MHz from either a 5 or 10 MHz XO. My guess is that it is 10 MHz like the > Rb. If it was me, I'd dismember the thing and either use existing (possible) > 5 or divide the (likely) 10 by 2 and have fewer steps in your chain. > > > > On 10/11/2010 4:00 PM, Richard W. Solomon wrote: > >> I would find 5 MHz more useful than 15 MHz. Can anyone >> recommend a divide-by-3 device I could use. I could add >> another connector to the front and just stick it inside. >> >> Thanks, Dick, W1KSZ >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> >> >> > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.