Thank you Rick, you obviously must know. Bert Kehren In a message dated 10/19/2010 12:02:11 P.M. Eastern Daylight Time, rich...@karlquist.com writes:
I think you should probably be fine at 18V. The oven will run down to at least 15V and maybe 12V. Rick Karlquist N6RK On 10/19/2010 5:27 AM, ewkeh...@aol.com wrote: > I plan on replacing the Xtal Osc. of my HP 5062C with a HP 10811 since I > have a few ones with AV less than 1E-12 from 1 to 100 sec. I would like to > use the +18 Volt in the unit for heater. Has any one experience with running > the 10811 below 20 Volt, any thing I should look out for? > Thanks Bert Kehren Miami > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.