Luis Cupido wrote:
Hi Don.
I'm ultra curious of how they did it. How did they covered the
full BW they have.
Did you looked inside, or did they sent a block diagram?
(...I was born curious... it is not a new symptom!)
Luis Cupido.
ct1dmk.
the manual is on the website..
some clues
Intermediate frequencies of 2.9 MHz and 10.7 MHz are used for all
frequencies. An RF input signal near these frequencies may generate
spurious responses and degrade the performance of the image rejection
algorithm.
Chapter 5 of the manual has the whole block diagram.. basically it's a
240kHz wide sampler, with a single/double conversion front end and a
bunch of switches. They do some clever signal processing in software
too, by stepping the LO and combining FFTs...
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
