Hi I certainly agree with that. The tubes in a "portable" cesium are done so they fit inside a specific box. In a lot of ways bigger is better if you are going to do it yourself. It would not at all be a trivial undertaking. It also would not be cheap.
Cs standards with dead tubes are indeed pretty cheap. I think I'd start with the electronics from one of them. Being able to do the tube stuff without having to do the electronics at the same time should make things a bit easier. You could swap out the electronics for your own once the tube was doing it's thing. Bob -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of J. Forster Sent: Thursday, January 13, 2011 11:24 AM To: Discussion of precise time and frequency measurement Subject: Re: [time-nuts] CS reservoir depletion As I said last go-round, I think the chances of rebuilding an HP Cs tube are slim to none. BUT, if you were really dedicated, I think you could build up the physics package from pretty much standard stuff, like the Kimball Physics gun parts and Conflat SS vacuum hardware, etc. Check Duniway. I'd start by reviewing the old, academic papers. Much of the electronics can be bought on eBay as instruments now. Yes, it'd be refrigerator size, but it is do-able, IMO. Best, -John ================== ] > You might find it interesting to look up the vapor pressure of > cesium at room temperature. > > To get the cesium to transport from where it has deposited to your > cold corner would require heating the whole tube up to where the > cesium would vaporize. I can't help but think that heating everything > in the tube that hot might cause other collateral damage... and the > cesium would certainly go and plate out on even more exciting places > than it did in normal operation. That might not be a good thing. > > I think this is a pay-to-play sort of thing. If you want to play > with a C-beam, you are going to have to pay. If you want one that > works like new, unless you are lucky, you might have to pay a lot. > > -Chuck Harris > > Neville Michie wrote: >> It sounds like you need to dip a corner of the device in liquid nitrogen >> and allow the metal to evaporate and condense in the cold corner. >> Or is it sublimation. >> I do not know how long it would take. >> cheers, Neville Michie > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
