Hi!
Yesterday I managed to trim away the unwanted RF from the 5 MHz output.
I fail to get as good result from the 10 MHz output, but I think it will
not be as big impact. Will possibly need to handle that. Spectrum
analyzer helps a lot more than a scope. Happy I invested in a faster
analog scope.
It is not a stable lock, even if I can se it lock in. I see too much
noise in it and the status flickers so I think I can blame the lamp
detection, need to check that. Possibly I will have to do the lamp
rejuvination trick. Also I need to figure out how to do the disassembly,
since I am not yet clear on how to best reach every part.
Most stuff is easy to get to...
But anyway, I make progress.
Cheers,
Magnus
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
