Just a word of caution to possible buyers of the Chinese Rubidium FE-5680A boxes. There has been a lot a discussion on the list lately about using the popular FE-5680A as a portable frequency standard and I have being working on using one of the cheap FE-5680A boxes myself. I have found that many of them do not output a useful 10 MHz signal. The 10 MHz output is not close to the expected frequency tolerance. The first of the units that I received puts out a signal at 9,999,945 Hz. The vendor then sent a second unit which puts out a signal at 10,000,025 Hz. The vendor is in China and while he has been willing to work with me by sending a second unit with me paying only postage, the time delay in shipping from China and the cost of postage is prohibitive. What concerns me the most is that the vendor says that both units were tested before shipping. In reviewing the Internet I found several other reports of similar problems with FE-5680A units. The units that I have been working with are FEI FE-5680AFEI P/N 217400-30352-1. These units all require a 5 volt input in addition to the 15 to 18 vdc input and these units are not programmable via an RS-232 port. These units are being advertised by several vendors on E-bay. I am sure that there are good FEI units available but there is no way of telling which are good and which are bad until you get the unit and check it out and if it is bad you may just be stuck with it, Only my experience yours, may be different Jerry
_______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
