Do you have the autotrigger (or whatever it is called) engaged? That will slow things down if it is hunting for the zero crossing.
Rick John Pease wrote: > > > > > > Hello, > > My new to me counter has a strange response when I change the input > frequency. With the gate set to 1s, I can measure 100 MHz with plenty of > digits. Then I change the frequency to 1 MHz and it takes several seconds > to almost a minute for the display to change from 100 MHz to 1 MHz. The > delay only occurs when I lower the input frequency quite a bit; 100 MHz to > 10 MHz changes are displayed within 2 gate times. When I increase the > frequency form 1 MHz to 100 MHz I always get the correct display after two > gate times. This delay is proportional to the gate time; the updating is > 10 times faster with 0.1 s gate time. > > Is this behavior typical for this counter? > > Thank you > > John Pease > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
