I have a manual for the counter which shows the block diagram but no
schematic.
An ICM7226A does the logic. The A channel has a 10 mHz clock using a
discrete
crystal. The power supply uses a transformer and appears to be linear.
A BNC connector next to the crystals could be repurposed to a 10 mHz input.
A small cap connected to one of the crystal leads might do????
On 10/01/2011 07:16 PM, Dave M wrote:
Picked up one of these today for $40.00.
Timebase to 10 seconds.
Supposed to use a 10 mHz timebase for channel A up to 100 mHz.
Any experience with this counter?
How hard to make it use the 10 mHz from a Thunderbolt?
Have no information on this counter, and assume that it's target
audience is consumer electronics service shops. Need to ask a couple
questions before making suggestions.
1) Does the counter have a jack on the rear panel for an external
time base, and a corresponding Int/Ext switch?
2) Do you have a manual or, at least, a schematic for it?
If the answer to Q1 is yes, then the solution is obvious... Connect
your Tbolt to the External Time Base input, and switch to External.
You might need a TTL level shifter to make it work.
If you have the schematic for the counter, and can scan the area
showing the internal oscillator, you might post it to a free file
sharing service so that we can look at the circuitry and make
intelligent suggestions.
If no manual or schematic, then you'll have to do a bit of
experimentation. Find the internal oscillator and scope the signal
level and freq. If it is, indeed, 10 MHz, then you'll need to find
out if the TBolt 10 MHz output can drive the circuitry. Is the
oscillator output at TTL levels (0/5 volts)? If it is, then you'll
have to build a level shifter to get the TBolt output to TTL levels.
Temporarily break the connection from the internal oscillator and hook
the TBolt in it's place. Scope the TBolt signal and make sure that
the counter circuitry isn't killing it. If everything works, you're
in good shape. If not, you might need to level shift the TBolt signal
to TTL levels. Find out as much as you can about the counter and come
back to the list with more info. We should be able to get you going.
David
dgminala at mediacombb dot net
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
--
Chuck Forsberg WA7KGX N2469R [email protected] www.omen.com
Developer of Industrial ZMODEM(Tm) for Embedded Applications
Omen Technology Inc "The High Reliability Software"
10255 NW Old Cornelius Pass Portland OR 97231 503-614-0430
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
