On 10/16/2011 07:57 PM, Mark Sims wrote:
I seem to remember that their rate was around $20 and hour... half that if you let them put the results in their for sale library. They did a 6x8" four layer board with components on each side for less than $250. It had a off-the-shelf DC-DC converter brick on it... the board came back with the brick de-potted and a schematic of its internals.
Decent enough!
I just tried their web site and it was not responding... hopefully they are not now extinct.
Hope for the better. Cheers, Magnus _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
