On 10/23/2011 06:31 PM, paul swed wrote:
Magnus have the 5061 assembly using a 5060 tube. Not sure that would help. I find virtually no information on the 5060. Never seen a manual. Regards Paul WB8TSL
I have the 5060A manual, but it is a little to brief to properly assist me. I got a strong nice 5 MHz, I believe I have good enough 10 MHz all the way to the trippling-diodes, but after this nothing.
I wanted to make sure I had my levels right so I could focus on the correct part of the multiplier chain.
A few more test-points would help, so I have to reverse-engineer in my head to probe the right places.
Also took a while to fiugre out that I needed to go into "Open Loop" mode to power up the A3 assembly.
The OCXO crystal filter needed calibration, it was way off. It was simple enough to resolve once I figured out I needed to lift the oscillator out of the clamps. Later 5060As has a separate hole next to the C-field adjustment.
Cheers, Magnus _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
