On 12/01/2011 11:18 AM, Attila Kinali wrote: > > Other than that one spot, i have to say that the whole device looks > like new. No dirt, no corrosion where you'd expect it. Even the solder > joints look like new. >
And I did not attempt to clean anything before I took the pictures, either. The only dirt was a grey tint above and below the oven, where the convection had deposited all non-gaseous dirt. I have a few of these, two of which have appear to have actual corrosion (rust red spots) on the outside, but are just as clean inside. I wonder what that does to the magnetic properties to the case. Posting to nuts is dangerous:-) So far the page has had 243 non-bot visitors, 20 people downloaded all the full resolution images, and it cost me 10GB this week. An impressive figure considering the topic. /Kasper Pedersen _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
