It looks like he laid out paper to use as a background and the PCB is just under the edge of one sheet.
-Bob On Mon, Dec 19, 2011 at 1:49 PM, <aartmol...@comcast.net> wrote: > I think the PCB cut off at ebay # 300628220912 is an image artifact. If > you look carefully you'll see the "cut" extend into the gray area on the > right. Fluke-L (it's "L", not i) wouldn't foist a sawn-off board to > sophisticated buyers. > > > Aart Olsen > > ----- Original Message ----- > From: "Ed Palmer" <ed_pal...@sasktel.net> > To: "Discussion of precise time and frequency measurement" < > time-nuts@febo.com> > Sent: Monday, December 19, 2011 9:16:32 AM > Subject: Re: [time-nuts] Another Trimble Thunderbolt-like GPS? > > It's not paranoia if it's true! :-) > > Take a look at the pictures for # 270725678037 . These boards don't > have the connector cut off of the corner of the board. Good eyes. > > Ed > > > On 12/19/2011 12:47 AM, Peter Bell wrote: > > Most of the parts (and their grouping) seem the same as the NTPX26AB - > > which based on my quick play with one seems to have basically the same > > hardware as a Thunderbolt. The only strange thing I noticed was that > > although it would work with the Trimble tbolt software Lady Heather > > couldn't recognize it. > > > > Maybe I'm being paranoid, but looking at that photo it looks like part > > of the board has been cut off - this would also explain the slightly > > evasive "I'll tell you where the power goes after you buy it". Of > > course, this won't necessarily stop it from working, but it might be > > worth checking. > > > > Regards, > > > > Pete > > > > > > On Mon, Dec 19, 2011 at 12:41 PM, Chris Albertson > > <albertson.ch...@gmail.com> wrote: > >> There are some Trimble GPS receivers on eBay. They say "10Mhz 1pps" > >> but they are not Thunderbolts. These are an A4 sized PCB, no > >> enclosure. The seller says it takes 48VDC to run. Seems reasonable > >> as there is a large DC/DC power converter in the board. > >> > >> Anyone know more? How to they compare to the Thunderbolt? > >> > >> Good photos at Auction #300628220912 > >> -- > >> > >> Chris Albertson > >> Redondo Beach, California > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.