Not the phase directly but the rate of change of the phase and this is exactly the way you can discipline an OCXO, phase included.
On Thu, Dec 22, 2011 at 8:57 PM, <[email protected]> wrote: > Using the digital input will only give you 7 E-13 steps. I will use it for > preset. > Bert Kehren > > > In a message dated 12/22/2011 2:50:23 P.M. Eastern Standard Time, > [email protected] writes: > > On Thu, Dec 22, 2011 at 9:52 AM, Chuck Forsberg WA7KGX N2469R > <[email protected]> wrote: > > You could disable the Tbolt's oscillator and put the Rb output in its > place. > > Then write a program that reads the PPS and/or OSC offset and issue > > appropriate commands to the Rb to bring it in line. > > I don't think it is possible to do that. The RS232 commands don't > allow the level of control that is required. All you can do is step > the frequency, no way to adjust the phase of the Rb 10MHz output. > > > Chris Albertson > Redondo Beach, California > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
