On 1/18/2012 7:35 PM, Peter Bell wrote:
Just out of interest, did you remove the connector and the faceplate
or was the board shipped to you like that?
The board had no faceplate when I got it, and from the PDF, "The
connector was broken and has been removed for these
pictures."
The board I have looks like this:
On Thu, Jan 19, 2012 at 10:10 AM, Rex<[email protected]> wrote:
Back in 2005 I got one of the FE-5680A rubidiums. The one I got came on the
full original circuit board. I thought I would make up a PDF to show what
the original board looked like and the kind of heat sink they mounted it on.
The board is large and has about 140 sq in of almost solid ground plane on
both the top and bottom.
The PDF that I created is here...
http://www.xertech.net/pub/5680A_Board.pdf
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
