Yes, you can, but you need to transplant the in-line power header in the "old" board to the "new" board and mount it on the "back" side of the pwb.
73, geo - n4ua On Fri, Mar 23, 2012 at 9:46 AM, J. L. Trantham <[email protected]> wrote: > Probably older. Date Code is 9932. > > However, I wonder if you could 'transplant' a newer TBolt into the case and > use the built in 24 VDC power supply? > > Joe > > -----Original Message----- > From: [email protected] [mailto:[email protected]] On > Behalf Of Stan, W1LE > Sent: Friday, March 23, 2012 8:34 AM > To: 'Discussion of precise time and frequency measurement' > Subject: [time-nuts] Trimble T'Bolt > > > Hello The Net, > > On Ebay: 120880795618 > > > Is this a very old T'Bolt or the newer e T'Bolt ? > > I like the single power supply even though it is 24VDC > > Stan, W1LE Cape Cod > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
