Juerg wrote:
Having a M12+Timing GPS driving the 1 Hz input of my PRS10. I decided to upgrade my house referenc switching to a Tbolt as the 1 Hz source. * * * Tests showed maximum deviation of 2 nsec with the Tbolt over 1000 seconds * * * Here are my questions: Are 2 nsec acceptable for a Tbolt
2 nS maximum deviation over 1000 seconds is good for a Tbolt, in my experience. You apparently have a good, strong signal from the satellites, low multipath, and an accurately surveyed antenna location.
What should the Tbolt loop time be for this application
That depends on a number of factors, primarily (i) the carrier-to-noise ratio you have (satellite signal strength) and (ii) the stability of the OCXO in your particular Tbolt. Basically, you want the OXCO to dominate up until it enters the random-walk phase. The best TC will probably be between 250 and 800 seconds to achieve this, in my experience. If the Tbolt goes into holdover from time to time, you may need to compromise between best absolute performance and holdover recovery.
What should the loop time be for the PRS10
The PRS10 manual addresses choosing setup parameters for disciplining the unit with the 1pps of a GPSDO.
What is the long term performance of the Tbolt and what is the contribution due to the GPS signal.
Generally, you can expect parts in 10^-13 at 10k seconds, dominated by the GPS deviation. If you have poor carrier-to-noise, somewhat worse.
What is the resolution of the Tbolt detecting and correcting the 1 pps and is it done by changing the OCXO frequency for short periods.
Yes, the 1pps is corrected by adjusting the OCXO. You can set the maximum allowed frequency error with TboltMON or Lady Heather (of course, if you set it too tight it will take forever to stabilize coming out of holdover). The Tbolt can also be set to slip cycles during recovery ("jam synch") to speed up the process. I don't think the adjustment resolution is an issue -- it is much smaller than the pps jitter.
You will be using a VERY slow loop in the PRS-10, so jitter in the GPSDO 1pps will not be much of a factor. The pps deviation at very long time scales (tens of hours and up) is what matters.
Best regards, Charles _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
