I think people have used video amps. I got one recently for nearly zero cost and it works as spec'd but video signals are typically 1 volt peak to peak and the amp is spec'd for "10MHz, 1dB" which means I'm right at the limit and I'm a 1 dB down, just as the spec says. Is 1V P-P enough for your equipment? This amp is easy to modify and I can greatly improve the specs by running it at +/- 15V rather then the +/-5V it now uses.
So, my opinion: Video distribution amps can work but you'll be right on the edge of the spec'd limits all around. On Sun, Mar 25, 2012 at 9:26 AM, cfo <xne...@luna.kyed.com> wrote: > I need a distribution amp for my Tbolt , with 6..8+ outputs > > The TAPR-1 is NA , and the successor status is ???. > > I need it for distributing 10Mhz ref-clock to Counters > (HP,Racal,Phillips), a Rigol Sig-gen & maybe Oscilloscopes etc. > > It's for "better than ocxo/hobby use" , and not Tnut (ps accuracy). > > I have seen suggestions for using a video distributiution unit. > But in my part of the world (EU) , there isn't a lot on "eby". > I have seen some RGB amps , and was wondering if i could use those ? > > Could i use a 1:6 RGB unit for : Tbolt on R , FEI-5680A on G - and ?? on > B ? > > I'm not experienced (yet) in the analog domain. > > If i go (simple diy) Would this one work (also wo. the trafo's) ? > http://www.oz9fw.dk/PDF%20files/rubidium.pdf > > I do have some trafo's on an old 10Mhz 8-chan Hub , that i might be able > to salvage if needed. > > Thanx for any input/hints > > CFo - T-Nut beginner Denmark. > > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. -- Chris Albertson Redondo Beach, California _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.