Thanks Randell Pete sent the link earlier. On Tue, Mar 27, 2012 at 4:45 PM, Randall Prentice < [email protected]> wrote:
> From GPS World > > > http://www.gpsworld.com/wireless/timing/news/ursanav-follows-second-wide-area-timing-tests-12793?utm_source=GPS&utm_medium=email&utm_campaign=navigate_03_27_2012&utm_content=ursanav-follows-second-wide-area-timing-tests-12793 > > Regards > Randall > -----Original Message----- > From: [email protected] [mailto:[email protected]] On > Behalf Of paul swed > Sent: Wednesday, 28 March 2012 9:34 a.m. > To: Time-nuts; paul swed > Subject: Re: [time-nuts] LORAN modulation scheme???? Kind of interesting > > Have to say the UrsaNav bunch is a bit difficult to reach. > Tried email and that was kicked back > Tried calling a couple of times and just hit an automated attendant and > they close at 430. > Good hours > Regards > > On Tue, Mar 27, 2012 at 4:23 PM, paul swed <[email protected]> wrote: > > > Perhaps its just noise. But LORAN went off the air. In the quite I > > hear some low level junk. > > Only I am beginning to think its not low level junk. > > > > It sounds like a GRI thats been spread and perhaps this is what a GRI > > sounds like when you do lots of phase reversals. > > My O my time to fire up the old austron 2000 gate a scope and see if > > this junk is synchronized. > > Have to believe I can do the same thing on the SRS FS700. > > Regards > > Paul > > WB8TSL > > Boston > > > _______________________________________________ > time-nuts mailing list -- [email protected] To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
