Hello, I’m a bit new to GPS receivers. I’m reading all about sawtooth correction of the 1 pps output signal, on the ilotus M12M or M12+.
I understand that correction can either be hardware controlled or software controlled. Does anyone make a low cost stand alone board to carry out this correction? I.E something that takes the raw 1 pps and serial data from the GPS receiver and produces a cleaner 1 pps output? I’ve seen that the peak to peak jitter is reduced from something like 27 ns to < 10 ns. Is this a reduction of just the jitter, or is the actual accuracy to UTC also improved by this amount. Regards Steve Jones _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
